Part II: Outrigger rigging Multiple clips by Kim Bain

In our first instalment on outriggers last month, we covered the reasoning behind why you might use outriggers on your boat (one outrigger on each side of the boat). Also we covered the basics of rigging them 'one-up' with a single pin-type release clip on each rigger.

In this edition we will look at rigging each outrigger with multiple release clips so that you can troll two or even three lines per outrigger. As a variation, we will also cover rigging outriggers with alternative release clips (e.g. both 'peg' and 'pin' styles of release clips).

If you want to run more than one line from each rigger you can either run two clips on the one rigger halyard or you can run two halyards with their own releases.

In my opinion, having two release clips on the same halyard makes it hard to fine tune the placement of each of your fishing lines. Also, the pressure of two lines connected to the same halyard sometimes compounds the problem of what I call 'halyard creep'. Halyard creep is the pressure on the rigger halyard that pulls it in ever so slightly and causes the clips to creep down, which reduces the tension in the fishing lines which can then allow tangles. The heavier bait or lure, i.e. the one creating the most drag, will take some tension off the other release clip. This then allows the other clip to twist or flip and tangle.

To avoid this, most crews running multiple clips will run each clip off a separate individual halyard in order to troll two or more baits off each outrigger.

Running each clip off an individual halyard also permits precise positioning adjustments for each release clip and therefore for each fishing line that is being trolled via a clip.

As covered last month, the basic rigging set-up has a mono-line type halyard that threads through a series of eyelets attached along the rigger pole, and the base end consists of a glass ring on shock cord.

When running two halyards, the longer one runs to the highest eyelet on the rigger (just like a single halyard rig) and the shorter one terminates at one of the eyes in the outrigger between halfway and two thirds up the pole.

At the baseoat end of the multiple halyard set-up you have a couple of options, mainly glass rings or pulleys. The photos accompanying this article will tell the story.

There pros and cons of using pulleys over glass rings. Although glass rings can shatter, they do offer enough friction between halyard and ring that the halyard is usually held in place. Unlocked pulleys allow halyard creep (the release clip vibrates down) unless you use Hal Locks or clip the two sides of each halyard together to stop them moving. You can use a flat line clip, like a giant clothes peg, to keep the halyard from creeping. Hal Locks are a roller pulley system with the ability to lock the linehalyard in place with the flip of a switch.

Now let's look at the photos.